Parrot Disco Bottom Camera 3 Inch Bubble Guard NEW

Description

Our new 3 Inch Bubble Guard makes for easier landings while
protecting
your camera.
Requires
our bottom mount unless you have your own design.
Our NEW Bubble Guard will give you about 3-3.5 inches of protection depending on camera mounting. This allows for sliding in on Disco belly instead of trying to land with our 6 inch guards. Includes the rear stabilizers as shown to
balance
landing.
(3/1/21) WE NO LONGER USE (THE BREAK AWAY CRASH STOPS) THESE ARE NOT INCLUDED
WE RECOMMEND THE BUBBLE GUARD OR 6” CRASH GUARDS
Weights:
Top Mount Disco 50-110g
Bottom Mount Disco 80-230g (depends on configuration)
Bubble Mount Assembly  75g (without camera)
Typical mounting with fasteners for 1 device 8-14g
Designed to be used as optional guard for our "
Parrot Disco Bottom Camera Mount-GP-Fusio
n-Sequoia-FLIR with w/o EVO SS Gimbal "
mount. (see photos)
Bubble Guard will protect cameras that do not exceed 3-3.5" in total height above the bottom mount
NOTE: You will need to adjust the Disco CG (center of gravity) for your camera and guard combination
DISCO NOT INCLUDED
(Custom mounting available send requirements for review)
COPYRIGHT © 2020 alienconcepts incorporated
Multiple units are available
MADE IN THE USA
General for All Mounts
We are constantly updating based on field use reports . As a result photos and instructions and components may change
at any time.
Disclaimer
We offer no guarantees  that a mount will perform up to your expectations since there are too many variables.
Use best practices for safe flying at all times . If unsure check with the FAA drone rules and regulations online.
We assume no responsibility for any damage or injury because of the addition of one of our mounts.
Payload Location and Clearance
When mounting payloads verify against recommended weights and sizes for your drone in manual or
contact manufacturer
If you mount anything on top of the mount make sure it has prop clearance a simple checking method is listed next for Inspire:
1-Place you DJI Inspire 1 or 2 in travel model with props on and look down from directly above make sure
you have clearance with nothing protruding outside of the drone main body envelope into prop space
2-If you do have payloads in the body envelope or you are unsure make styrofoam size model and affix it with double stick
or velcro. Manually move the jack screw through its full range and make sure there is no interference with the props.
Safeguards
Use a safety lanyard on your mounts. This is one I use : Amazon
MIZUGIWA Stainless Steel Lanyard Cable Tether Safety Wire for Loss Prevention 2 Loops w/Quick Release Ring & Rubber Coating 12" Set of 10