Parrot Disco Bot Top Camera Mount with Bubble Guard for Sequoia-FLIR-Agrocam

Description

Our new Bubble Guard makes for easier landings while protectiing your camera. Mounts accept
FLIR VUE
, Sequoia Multi spectral or any type of GoPro style
auxiliary camera like a GoPro Session, Hero, Fusion or AgroCam on bottom or top of your Parrot Disco series.  GoPro buckle mounting allows maximum camera flexibility
(3/1/21) WE NO LONGER USE (THE BREAK AWAY CRASH STOPS) THESE ARE NOT INCLUDED
WE RECOMMEND THE BUBBLE GUARD OR 6” CRASH GUARDS
Parrot DISCO NOT INCLUDED
Price includes bottom and top mounts and our NEW Bubble Guard
.
Weights:
Top Mount Disco 50-110g
Bottom Mount Disco 80-230g (depends on configuration)
Typical mounting with fasteners for 1 device 8-14g
1-Includes adaptor to accept any GoPro style mounting buckle (see photos) Sequoia and FLIR VUE
2-
Your can attach any camera that adheres to GoPro size standards or we can create a custom mount for you. (Check payload weight total)
3- If you need a power pak for camera such as FLIR VUE or Parrot
Sequoia
it can be attached to the bottom mount which has 5.5 inches of mounting area
or you can p
lace
under cowling.
(Attom Tech Ultra Compact 5000-mah Dual USB Outputs Super Slim Power Bank on Amazon is ideal for this use)
4- We offer a optional mounting frame for the EVO SS when used with the GoPro Hero 8 Black search for
EVO SS GoPro HERO8 BLACK Mounting Kit Dual Position
on Ebay
5- Bubble Guard will protect cameras that do not exceed 3" in total height above the bottom mount
NOTE:
You will not need to modify your Disco body with the top mount if you stay within the 110g limit
You will need to adjust the Disco CG (center of gravity) for your camera combination
Adaptor clamps forGoPro Style CAmeras, Parrot Sequoia and FLIR VUE included
Sequoia includes a top and bottom mount since it has a camera and sunlight component
(Custom mounting available send requirements for review)
COPYRIGHT © 2020 alienconcepts incorporated
Multiple units are available
MADE IN THE USA
General for All Mounts
We are constantly updating based on field use reports . As a result photos and instructions and components may change
at any time.
Disclaimer
We offer no guarantees  that a mount will perform up to your expectations since there are too many variables.
Use best practices for safe flying at all times . If unsure check with the FAA drone rules and regulations online.
We assume no responsibility for any damage or injury because of the addition of one of our mounts.
Payload Location and Clearance
When mounting payloads verify against recommended weights and sizes for your drone in manual or
contact manufacturer
If you mount anything on top of the mount make sure it has prop clearance a simple checking method is listed next for Inspire:
1-Place you DJI Inspire 1 or 2 in travel model with props on and look down from directly above make sure
you have clearance with nothing protruding outside of the drone main body envelope into prop space
2-If you do have payloads in the body envelope or you are unsure make styrofoam size model and affix it with double stick
or velcro. Manually move the jack screw through its full range and make sure there is no interference with the props.
Safeguards
Use a safety lanyard on your mounts. This is one I use : Amazon
MIZUGIWA Stainless Steel Lanyard Cable Tether Safety Wire for Loss Prevention 2 Loops w/Quick Release Ring & Rubber Coating 12" Set of 10