DJI Mavic 2 Triple Mount for-GoPro-Sequoia-FLIR-Lighting NEW VERSION

Description

MAVIC 2 Dual Bottom Mount for two GoPro style cameras, lights or accessories.
Accessories
and/or cameras are underneath the
rotors and do not block sensors. The dual mounts keep drone in balance. Removes in a couple minutes
LESS THEN HALF THE PRICE OF COMPETIVE DUAL LIGHTING MOUNTS
You can buy our mount and 2
ULANZI L1 Pro Mini LED Light Waterproof LED lights for half the price
of other products
DRONE, CAMERA and LIGHT NOT INCLUDED
NEW UPDATE (06/0621):
We have added a top tensioner that can be used to preload the bottom dual mount and damp vibrations when using
heavy items and add a top device. The tensioner slips on and off to make battery removal easy. (see photos)
Updated version allows for quick removal of top mount to change battery
Includes all necessary mounting hardware
GREY Version
Weights:
Dual Mount 30-40g
Tested Payload Limit 460g (GoPro 8 , prop guards, top camera and Lighting)
SAMPLE VIDEO   Rear Facing Hero 8 at 4k x 60FPS
https://youtu.be/PytVGAjpx9I
Sample Video Front facing Hero 9 at 4K x 60FPS
https://youtu.be/gF_Y2lhmV4Q
SAMPLE VIDEO   MAX 360 at 5.2k x 30FPS
Coming
This is for
MAVIC 2 Series (not Original MAVIC)
1-Includes adaptor to accept any GoPro style mounting (see photos)
(watch the video for stability)
2- Mount your camera in almost any position up, down, front or rear facing or at angle
3- Mount your lighting using 1/4 to GoPro swivel adaptors for precise
aiming
4- Attaches in a few minutes
5- Adaptor for Sequoia Coming
6- I use leg extensions however, you can land on camera and/or lighting bottom
- These work well
PGYTECH Extended Landing Gear Leg Support
- This is a nice light at a reasonable price
ULANZI L1 Pro Mini LED Light Waterproof LED
This mount is not a
replacement
for the standrad DJI front mount camera however you could use as your only camera if you do not have a front camera.
COPYRIGHT © 2020 alienconcepts incorporated
Multiple units are available
MADE IN THE USA
General for All Mounts
We are constantly updating based on field use reports . As a result photos and instructions and components may change
at any time.
Disclaimer
We offer no guarantees  that a mount will perform up to your expectations since there are too many variables.
Use best practices for safe flying at all times . If unsure check with the FAA drone rules and regulations online.
We assume no responsibility for any damage or injury because of the addition of one of our mounts.
Payload Location and Clearance
When mounting payloads verify against recommended weights and sizes for your drone in manual or
contact manufacturer
If you mount anything on top of the mount make sure it has prop clearance a simple checking method is listed next:
1-Place you DJI Inspire 1 or 2 in travel model with props on and look down from directly above make sure
you have clearance with nothing protruding outside of the drone main body envelope into prop space
(the same idea can be applied to any drone)
2-If you do have payloads in the body envelope or you are unsure make styrofoam size model and affix it with double stick
or velcro. Manually move the props through the full range and make sure there is no interference .
Safeguards
Use a safety lanyard on your mounts. This is one I use : Amazon
MIZUGIWA Stainless Steel Lanyard Cable Tether Safety Wire for Loss Prevention 2 Loops w/Quick Release Ring & Rubber Coating 12" Set of 10